EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IW9GTR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IW9GTR-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1762804146	113 Count	240 Count	102 Count
1762802937	94 Count	192 Count	85 Count
1762801728	76 Count	143 Count	69 Count
1762800520	58 Count	107 Count	53 Count
1762799311	40 Count	64 Count	37 Count
1762798102	18 Count	28 Count	17 Count
1762796890	525 Count	1007 Count	469 Count
1762795680	502 Count	972 Count	448 Count
1762794472	481 Count	936 Count	429 Count
1762793435	464 Count	904 Count	414 Count
1762792226	445 Count	856 Count	397 Count
1762791018	423 Count	814 Count	378 Count
1762789803	402 Count	779 Count	359 Count
1762788595	380 Count	744 Count	339 Count
1762787386	363 Count	709 Count	324 Count
1762786176	342 Count	674 Count	305 Count
1762784968	325 Count	629 Count	290 Count
1762783759	308 Count	582 Count	275 Count
1762782545	286 Count	550 Count	255 Count
1762781337	263 Count	511 Count	234 Count
1762780128	247 Count	477 Count	220 Count
1762778919	228 Count	440 Count	203 Count
1762777710	213 Count	406 Count	190 Count
1762776496	192 Count	365 Count	171 Count
1762775288	171 Count	334 Count	152 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)