EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5UID-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1775500872	7 Count	354 Count
1775499635	6 Count	352 Count
1775497833	5 Count	265 Count
1775496037	4 Count	189 Count
1775494235	3 Count	143 Count
1775492434	2 Count	92 Count
1775490633	1 Count	75 Count
1775488836	0 Count	46 Count
1775487035	18 Count	1046 Count
1775485234	17 Count	995 Count
1775483432	15 Count	906 Count
1775483399	14 Count	906 Count
1775481597	13 Count	819 Count
1775479796	12 Count	723 Count
1775477994	11 Count	634 Count
1775476197	10 Count	541 Count
1775474396	9 Count	493 Count
1775472595	8 Count	411 Count
1775470793	7 Count	352 Count
1775469556	6 Count	352 Count
1775467759	5 Count	292 Count
1775465957	4 Count	212 Count
1775464157	2 Count	157 Count
1775462356	1 Count	108 Count
1775460558	0 Count	52 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)