EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5UID-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1762810045	2 Count	155 Count
1762810031	4 Count	311 Count
1762808303	1 Count	95 Count
1762808230	3 Count	242 Count
1762806562	0 Count	17 Count
1762806428	2 Count	163 Count
1762804821	15 Count	1051 Count
1762804627	1 Count	139 Count
1762803080	14 Count	1000 Count
1762802826	0 Count	81 Count
1762801338	13 Count	948 Count
1762801024	15 Count	1063 Count
1762799596	12 Count	834 Count
1762799223	14 Count	956 Count
1762797855	11 Count	783 Count
1762797421	13 Count	887 Count
1762796114	10 Count	720 Count
1762795620	12 Count	832 Count
1762794373	9 Count	671 Count
1762793819	11 Count	768 Count
1762792631	8 Count	612 Count
1762792017	10 Count	713 Count
1762790890	7 Count	518 Count
1762790216	9 Count	584 Count
1762789148	6 Count	405 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)