EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2WM-17 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WM-17. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1790013508	123 Count	999 Count
1790012607	122 Count	995 Count
1790011706	121 Count	992 Count
1790010805	120 Count	985 Count
1790009004	118 Count	976 Count
1790008103	117 Count	973 Count
1790007202	116 Count	969 Count
1790006301	115 Count	965 Count
1790005401	114 Count	961 Count
1790004500	113 Count	957 Count
1790003600	112 Count	953 Count
1790002698	111 Count	936 Count
1790001798	110 Count	923 Count
1790000896	109 Count	919 Count
1790000015	104 Count	913 Count
1789999114	103 Count	910 Count
1789998213	102 Count	907 Count
1789997312	101 Count	904 Count
1789996411	100 Count	896 Count
1789995511	99 Count	891 Count
1789994610	98 Count	888 Count
1789993709	97 Count	884 Count
1789992808	96 Count	867 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)