EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2CPA-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791453050	221 Count	450 Count
1791451249	218 Count	437 Count
1791449448	214 Count	433 Count
1791447648	210 Count	429 Count
1791445847	206 Count	425 Count
1791444046	202 Count	421 Count
1791442245	198 Count	417 Count
1791440453	194 Count	413 Count
1791438652	190 Count	409 Count
1791436851	186 Count	405 Count
1791435050	182 Count	401 Count
1791433250	178 Count	397 Count
1791431449	174 Count	393 Count
1791429648	170 Count	388 Count
1791427847	166 Count	383 Count
1791422445	154 Count	362 Count
1791420644	150 Count	356 Count
1791418852	146 Count	351 Count
1791417052	142 Count	347 Count
1791413450	135 Count	340 Count
1791411649	131 Count	336 Count
1791409848	127 Count	332 Count
1791408048	123 Count	328 Count
1791406247	119 Count	324 Count
1791404446	115 Count	320 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)