EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2YBC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2YBC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RX*	Digi*
1787562922	752 Count	264 Count
1787561122	705 Count	248 Count
1787559322	646 Count	221 Count
1787557522	593 Count	198 Count
1787555723	550 Count	184 Count
1787553923	505 Count	166 Count
1787552123	457 Count	152 Count
1787550322	395 Count	130 Count
1787548522	348 Count	113 Count
1787546722	290 Count	94 Count
1787544921	227 Count	75 Count
1787543121	165 Count	56 Count
1787541321	108 Count	39 Count
1787539521	61 Count	23 Count
1787537721	1044 Count	334 Count
1787535921	994 Count	317 Count
1787534123	947 Count	302 Count
1787532323	886 Count	283 Count
1787530523	830 Count	264 Count
1787528721	774 Count	245 Count
1787526921	724 Count	228 Count
1787525121	657 Count	209 Count
1787523320	595 Count	193 Count
1787521520	532 Count	172 Count
1787519720	480 Count	155 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)