EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IU0VBE-7 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU0VBE-7. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1787557804	608 Count	593 Count	150 Count
1787556001	607 Count	593 Count	150 Count
1787554198	606 Count	593 Count	150 Count
1787552395	605 Count	593 Count	150 Count
1787550592	604 Count	593 Count	150 Count
1787548789	603 Count	593 Count	150 Count
1787547022	602 Count	593 Count	150 Count
1787545219	601 Count	593 Count	150 Count
1787543416	600 Count	593 Count	150 Count
1787541613	599 Count	593 Count	150 Count
1787539809	598 Count	593 Count	150 Count
1787538006	597 Count	593 Count	150 Count
1787536203	596 Count	593 Count	150 Count
1787534400	595 Count	593 Count	150 Count
1787532597	594 Count	593 Count	150 Count
1787530794	593 Count	593 Count	150 Count
1787528991	592 Count	593 Count	150 Count
1787527187	591 Count	593 Count	150 Count
1787525421	590 Count	593 Count	150 Count
1787523618	589 Count	593 Count	150 Count
1787521815	588 Count	593 Count	150 Count
1787520011	587 Count	593 Count	150 Count
1787518208	586 Count	593 Count	150 Count
1787516405	585 Count	593 Count	150 Count
1787514602	584 Count	593 Count	150 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)