EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP4SAS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4SAS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791486655	256 Count	475 Count	213 Count
1791484853	244 Count	452 Count	203 Count
1791483052	215 Count	401 Count	176 Count
1791482151	202 Count	383 Count	164 Count
1791481251	196 Count	372 Count	159 Count
1791480350	191 Count	361 Count	155 Count
1791479449	186 Count	351 Count	151 Count
1791478548	180 Count	343 Count	146 Count
1791477648	175 Count	334 Count	142 Count
1791476762	167 Count	323 Count	139 Count
1791475862	161 Count	311 Count	134 Count
1791474961	154 Count	301 Count	128 Count
1791474060	148 Count	293 Count	123 Count
1791473160	141 Count	282 Count	117 Count
1791472259	136 Count	268 Count	113 Count
1791471358	128 Count	256 Count	106 Count
1791470458	122 Count	242 Count	101 Count
1791469557	116 Count	229 Count	96 Count
1791468656	105 Count	209 Count	86 Count
1791467756	97 Count	192 Count	79 Count
1791466855	91 Count	178 Count	74 Count
1791465053	82 Count	160 Count	67 Count
1791463252	73 Count	142 Count	60 Count
1791462351	66 Count	125 Count	54 Count
1791461451	53 Count	101 Count	42 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)