EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SV3GCB-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV3GCB-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1785100329	390 Count	387 Count	201 Count
1785099723	388 Count	385 Count	200 Count
1785099119	386 Count	383 Count	199 Count
1785098514	384 Count	381 Count	198 Count
1785097909	382 Count	379 Count	197 Count
1785097303	380 Count	377 Count	196 Count
1785096699	378 Count	375 Count	195 Count
1785096094	376 Count	373 Count	194 Count
1785095489	374 Count	371 Count	193 Count
1785094884	372 Count	369 Count	192 Count
1785094279	370 Count	367 Count	191 Count
1785093674	368 Count	365 Count	190 Count
1785093069	366 Count	363 Count	189 Count
1785092464	361 Count	358 Count	185 Count
1785091859	359 Count	356 Count	184 Count
1785091254	357 Count	354 Count	183 Count
1785090650	355 Count	352 Count	182 Count
1785090045	353 Count	350 Count	181 Count
1785089440	351 Count	348 Count	180 Count
1785088836	349 Count	346 Count	179 Count
1785088231	347 Count	344 Count	178 Count
1785087626	345 Count	342 Count	177 Count
1785087021	343 Count	340 Count	176 Count
1785086417	341 Count	338 Count	175 Count
1785085812	339 Count	336 Count	174 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)