EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2ZXT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ZXT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1783298651	354 Count	936 Count	284 Count
1783296850	351 Count	926 Count	282 Count
1783295049	348 Count	918 Count	280 Count
1783293249	345 Count	908 Count	278 Count
1783291448	339 Count	896 Count	273 Count
1783289647	336 Count	887 Count	271 Count
1783287846	333 Count	878 Count	269 Count
1783286051	330 Count	868 Count	267 Count
1783284250	327 Count	858 Count	265 Count
1783282449	324 Count	849 Count	263 Count
1783280649	321 Count	836 Count	261 Count
1783278848	318 Count	828 Count	259 Count
1783277047	302 Count	798 Count	244 Count
1783275246	299 Count	790 Count	242 Count
1783273446	296 Count	783 Count	240 Count
1783271645	293 Count	778 Count	238 Count
1783269844	281 Count	763 Count	227 Count
1783268044	278 Count	757 Count	225 Count
1783266243	275 Count	751 Count	223 Count
1783264449	272 Count	746 Count	221 Count
1783262649	269 Count	741 Count	219 Count
1783260848	266 Count	735 Count	217 Count
1783259047	263 Count	725 Count	215 Count
1783257246	260 Count	719 Count	213 Count
1783255446	257 Count	713 Count	211 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)