EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

DJ1FC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DJ1FC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1791446626	44 Count	293 Count
1791443018	42 Count	276 Count
1791439410	40 Count	273 Count
1791435801	38 Count	265 Count
1791432193	36 Count	260 Count
1791428585	34 Count	254 Count
1791424977	32 Count	242 Count
1791421369	30 Count	232 Count
1791417761	28 Count	226 Count
1791414153	26 Count	217 Count
1791410545	24 Count	211 Count
1791406937	22 Count	202 Count
1791403329	20 Count	188 Count
1791399720	18 Count	173 Count
1791396112	16 Count	164 Count
1791392504	14 Count	150 Count
1791388896	12 Count	138 Count
1791385434	10 Count	125 Count
1791381826	8 Count	108 Count
1791378218	6 Count	81 Count
1791374610	4 Count	46 Count
1791371002	2 Count	24 Count
1791367393	0 Count	6 Count
1791363785	86 Count	996 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)