EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

2E0LXY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 2E0LXY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1783289323	199 Count	444 Count	84 Count
1783288720	179 Count	434 Count	81 Count
1783288116	175 Count	422 Count	78 Count
1783287514	164 Count	407 Count	75 Count
1783287034	161 Count	396 Count	74 Count
1783286431	157 Count	377 Count	71 Count
1783285827	154 Count	360 Count	69 Count
1783285224	150 Count	344 Count	66 Count
1783284620	141 Count	326 Count	61 Count
1783284017	136 Count	310 Count	58 Count
1783283414	131 Count	293 Count	54 Count
1783282810	124 Count	282 Count	52 Count
1783282207	115 Count	262 Count	47 Count
1783281604	109 Count	245 Count	44 Count
1783281000	103 Count	230 Count	40 Count
1783280397	97 Count	213 Count	37 Count
1783279794	93 Count	199 Count	34 Count
1783279190	89 Count	180 Count	31 Count
1783278587	82 Count	166 Count	27 Count
1783277983	71 Count	146 Count	23 Count
1783277380	65 Count	132 Count	20 Count
1783276777	55 Count	121 Count	19 Count
1783276173	51 Count	109 Count	16 Count
1783275570	48 Count	93 Count	14 Count
1783274967	44 Count	77 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)