EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

G6MXT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object G6MXT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791447849	757 Count	280 Count	239 Count
1791447778	752 Count	280 Count	239 Count
1791447656	747 Count	280 Count	239 Count
1791447518	742 Count	280 Count	239 Count
1791447435	737 Count	280 Count	239 Count
1791446671	732 Count	280 Count	239 Count
1791444868	730 Count	279 Count	238 Count
1791443064	728 Count	278 Count	237 Count
1791441261	726 Count	277 Count	236 Count
1791439458	724 Count	275 Count	235 Count
1791437692	715 Count	271 Count	231 Count
1791435889	709 Count	266 Count	226 Count
1791434086	707 Count	265 Count	225 Count
1791432282	705 Count	264 Count	224 Count
1791430479	703 Count	263 Count	223 Count
1791428676	701 Count	262 Count	222 Count
1791426872	699 Count	261 Count	221 Count
1791425069	697 Count	260 Count	220 Count
1791423266	695 Count	259 Count	219 Count
1791419659	691 Count	257 Count	217 Count
1791417855	689 Count	256 Count	216 Count
1791416090	683 Count	255 Count	215 Count
1791414287	681 Count	254 Count	214 Count
1791412483	679 Count	253 Count	213 Count
1791410680	677 Count	252 Count	212 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)