EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

KC7HES-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KC7HES-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1787553384	321 Count	187 Count	11 Count
1787551584	250 Count	142 Count	9 Count
1787549784	165 Count	93 Count	6 Count
1787547983	72 Count	41 Count	3 Count
1787546183	1011 Count	598 Count	34 Count
1787544383	956 Count	559 Count	32 Count
1787542583	886 Count	516 Count	30 Count
1787540786	820 Count	470 Count	27 Count
1787538986	744 Count	427 Count	24 Count
1787537186	667 Count	381 Count	21 Count
1787535385	598 Count	328 Count	18 Count
1787533585	508 Count	276 Count	15 Count
1787531785	424 Count	224 Count	12 Count
1787529984	310 Count	164 Count	9 Count
1787528184	200 Count	106 Count	6 Count
1787526384	101 Count	54 Count	3 Count
1787524583	1083 Count	684 Count	35 Count
1787522782	992 Count	625 Count	33 Count
1787520982	906 Count	573 Count	29 Count
1787519185	822 Count	521 Count	26 Count
1787517385	737 Count	464 Count	23 Count
1787515584	649 Count	410 Count	21 Count
1787513784	563 Count	355 Count	18 Count
1787511984	456 Count	305 Count	15 Count
1787510183	367 Count	254 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)