EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

XE2OK-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XE2OK-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791476885	269 Count	421 Count	210 Count
1791475982	262 Count	411 Count	204 Count
1791475079	255 Count	401 Count	198 Count
1791474176	250 Count	393 Count	194 Count
1791473273	246 Count	387 Count	191 Count
1791472370	240 Count	379 Count	186 Count
1791471467	236 Count	374 Count	183 Count
1791470568	230 Count	366 Count	178 Count
1791469732	222 Count	360 Count	175 Count
1791468828	217 Count	351 Count	171 Count
1791467925	213 Count	345 Count	168 Count
1791467022	207 Count	337 Count	163 Count
1791466119	203 Count	333 Count	160 Count
1791465216	199 Count	327 Count	157 Count
1791464313	195 Count	323 Count	154 Count
1791463410	189 Count	316 Count	149 Count
1791462507	185 Count	310 Count	146 Count
1791461604	180 Count	302 Count	142 Count
1791460701	176 Count	294 Count	139 Count
1791459798	170 Count	285 Count	134 Count
1791458895	167 Count	277 Count	132 Count
1791457992	161 Count	268 Count	127 Count
1791457089	157 Count	260 Count	124 Count
1791456186	151 Count	250 Count	119 Count
1791455282	147 Count	243 Count	116 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)