EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

XQ3PCN-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XQ3PCN-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1787543487	41 Count	448 Count
1787542583	33 Count	421 Count
1787541679	32 Count	388 Count
1787540776	31 Count	357 Count
1787539872	30 Count	326 Count
1787538968	22 Count	298 Count
1787538064	21 Count	270 Count
1787537160	20 Count	243 Count
1787536257	19 Count	212 Count
1787535353	10 Count	180 Count
1787534449	9 Count	147 Count
1787533545	8 Count	123 Count
1787532641	7 Count	92 Count
1787531738	2 Count	62 Count
1787530834	1 Count	40 Count
1787529930	0 Count	0 Count
1787528217	41 Count	946 Count
1787527313	40 Count	907 Count
1787526410	39 Count	876 Count
1787525506	38 Count	844 Count
1787524602	37 Count	810 Count
1787523698	36 Count	785 Count
1787522795	35 Count	748 Count
1787521891	34 Count	711 Count
1787520987	33 Count	660 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)