EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

OK1FWG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1FWG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762822973	737 Count	679 Count	672 Count
1762821170	734 Count	679 Count	672 Count
1762819366	733 Count	679 Count	672 Count
1762817563	732 Count	679 Count	672 Count
1762815760	711 Count	658 Count	652 Count
1762813957	683 Count	632 Count	626 Count
1762812154	647 Count	596 Count	591 Count
1762810351	611 Count	561 Count	556 Count
1762808548	576 Count	528 Count	523 Count
1762806745	546 Count	501 Count	496 Count
1762804942	523 Count	479 Count	474 Count
1762803134	501 Count	458 Count	453 Count
1762801331	467 Count	426 Count	421 Count
1762799528	430 Count	392 Count	387 Count
1762797725	401 Count	364 Count	359 Count
1762795922	384 Count	348 Count	343 Count
1762794118	354 Count	321 Count	316 Count
1762792315	328 Count	297 Count	292 Count
1762790511	308 Count	277 Count	273 Count
1762788708	298 Count	269 Count	265 Count
1762786905	266 Count	240 Count	236 Count
1762785102	247 Count	223 Count	219 Count
1762783299	223 Count	200 Count	196 Count
1762781496	194 Count	171 Count	168 Count
1762779693	180 Count	159 Count	156 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)