EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2BC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2BC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1783299714	3 Count	21 Count	2 Count
1783297913	1 Count	10 Count	1 Count
1783296112	257 Count	1008 Count	141 Count
1783294311	254 Count	999 Count	139 Count
1783292521	252 Count	991 Count	138 Count
1783290720	250 Count	977 Count	137 Count
1783288919	248 Count	967 Count	136 Count
1783287119	246 Count	958 Count	135 Count
1783285318	243 Count	952 Count	133 Count
1783283517	241 Count	943 Count	132 Count
1783281716	239 Count	935 Count	131 Count
1783279915	237 Count	927 Count	130 Count
1783278114	235 Count	919 Count	129 Count
1783276313	232 Count	910 Count	127 Count
1783274512	230 Count	905 Count	126 Count
1783272711	228 Count	899 Count	125 Count
1783270921	226 Count	889 Count	124 Count
1783269120	224 Count	882 Count	123 Count
1783267319	221 Count	871 Count	121 Count
1783265519	219 Count	862 Count	120 Count
1783263718	217 Count	854 Count	119 Count
1783261917	215 Count	846 Count	118 Count
1783260116	213 Count	838 Count	117 Count
1783258315	210 Count	832 Count	115 Count
1783256514	208 Count	823 Count	114 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)