EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2ST-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ST-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1783304280	896 Count	447 Count	213 Count
1783302599	878 Count	437 Count	208 Count
1783300919	863 Count	427 Count	204 Count
1783299238	839 Count	415 Count	198 Count
1783297557	823 Count	406 Count	194 Count
1783295876	802 Count	394 Count	188 Count
1783294195	784 Count	384 Count	183 Count
1783292515	766 Count	374 Count	178 Count
1783290834	745 Count	362 Count	172 Count
1783289403	727 Count	355 Count	169 Count
1783287722	706 Count	344 Count	164 Count
1783286041	683 Count	332 Count	158 Count
1783282679	637 Count	310 Count	149 Count
1783280998	616 Count	299 Count	143 Count
1783279317	600 Count	289 Count	139 Count
1783277637	581 Count	278 Count	134 Count
1783275956	563 Count	268 Count	129 Count
1783274275	540 Count	257 Count	124 Count
1783272594	520 Count	245 Count	118 Count
1783270913	500 Count	233 Count	113 Count
1783269233	472 Count	221 Count	107 Count
1783267802	451 Count	214 Count	104 Count
1783266121	411 Count	202 Count	99 Count
1783264440	372 Count	190 Count	93 Count
1783262759	348 Count	174 Count	88 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)