EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2HCA-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1775492214	33 Count	36 Count	19 Count
1775488612	28 Count	29 Count	16 Count
1775486811	26 Count	27 Count	15 Count
1775485010	23 Count	23 Count	13 Count
1775483209	20 Count	21 Count	11 Count
1775481409	17 Count	18 Count	9 Count
1775479616	11 Count	13 Count	8 Count
1775477815	8 Count	9 Count	6 Count
1775476014	5 Count	7 Count	4 Count
1775474213	2 Count	4 Count	2 Count
1775472413	1003 Count	1005 Count	728 Count
1775470612	997 Count	999 Count	723 Count
1775468811	995 Count	997 Count	722 Count
1775467010	992 Count	993 Count	720 Count
1775465210	989 Count	990 Count	718 Count
1775463409	986 Count	987 Count	716 Count
1775461610	983 Count	984 Count	714 Count
1775458014	974 Count	978 Count	711 Count
1775456213	971 Count	975 Count	709 Count
1775454414	968 Count	972 Count	707 Count
1775452612	965 Count	965 Count	705 Count
1775450811	962 Count	960 Count	703 Count
1775449010	956 Count	950 Count	698 Count
1775447210	953 Count	939 Count	696 Count
1775445409	950 Count	931 Count	694 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)