EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

PE1PMD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PE1PMD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1783314867	147 Count	330 Count	124 Count
1783313964	143 Count	320 Count	121 Count
1783313057	106 Count	281 Count	85 Count
1783312151	83 Count	251 Count	63 Count
1783311247	70 Count	236 Count	51 Count
1783310344	65 Count	222 Count	47 Count
1783309440	61 Count	209 Count	44 Count
1783308537	58 Count	199 Count	42 Count
1783307633	55 Count	187 Count	40 Count
1783306730	52 Count	176 Count	38 Count
1783305826	48 Count	163 Count	35 Count
1783304923	42 Count	152 Count	33 Count
1783304019	38 Count	138 Count	30 Count
1783303116	34 Count	125 Count	27 Count
1783302212	28 Count	107 Count	22 Count
1783301308	24 Count	92 Count	19 Count
1783300405	19 Count	77 Count	15 Count
1783299501	16 Count	63 Count	13 Count
1783298598	11 Count	45 Count	9 Count
1783297694	7 Count	33 Count	6 Count
1783296882	3 Count	17 Count	3 Count
1783295978	387 Count	1012 Count	293 Count
1783295074	381 Count	998 Count	288 Count
1783294171	377 Count	985 Count	285 Count
1783293267	373 Count	970 Count	282 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)