EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

M9NSZ-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M9NSZ-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1783282853	745 Count	964 Count
1783281050	744 Count	956 Count
1783279247	743 Count	952 Count
1783277444	742 Count	947 Count
1783275641	741 Count	944 Count
1783273838	740 Count	941 Count
1783272035	739 Count	937 Count
1783270231	738 Count	929 Count
1783268428	737 Count	918 Count
1783266625	736 Count	913 Count
1783264822	735 Count	908 Count
1783263054	734 Count	905 Count
1783261251	733 Count	902 Count
1783259448	732 Count	898 Count
1783257645	731 Count	896 Count
1783255842	730 Count	889 Count
1783254039	729 Count	888 Count
1783252236	728 Count	881 Count
1783250433	727 Count	876 Count
1783248630	726 Count	872 Count
1783246827	725 Count	869 Count
1783245024	724 Count	865 Count
1783243221	723 Count	861 Count
1783241454	722 Count	858 Count
1783239651	721 Count	855 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)