EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

DL1KDA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL1KDA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1782326280	108 Count	221 Count	97 Count
1782324475	100 Count	206 Count	90 Count
1782322671	96 Count	192 Count	87 Count
1782320867	88 Count	165 Count	80 Count
1782319062	83 Count	156 Count	76 Count
1782317258	78 Count	143 Count	72 Count
1782315454	75 Count	130 Count	70 Count
1782313650	67 Count	109 Count	63 Count
1782311846	61 Count	82 Count	58 Count
1782310086	46 Count	60 Count	44 Count
1782308282	20 Count	29 Count	19 Count
1782306477	0 Count	0 Count	0 Count
1782304673	432 Count	1003 Count	390 Count
1782302869	430 Count	999 Count	389 Count
1782301065	416 Count	974 Count	376 Count
1782299261	319 Count	852 Count	280 Count
1782297456	303 Count	823 Count	265 Count
1782295652	279 Count	792 Count	242 Count
1782293848	272 Count	777 Count	236 Count
1782292044	263 Count	762 Count	228 Count
1782290240	260 Count	747 Count	226 Count
1782288486	243 Count	699 Count	210 Count
1782286681	240 Count	691 Count	208 Count
1782284877	222 Count	655 Count	191 Count
1782283072	218 Count	635 Count	188 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)