EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

ON4CDR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ON4CDR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1779395142	40 Count	197 Count
1779394239	28 Count	123 Count
1779393335	14 Count	54 Count
1779392432	369 Count	1030 Count
1779391527	354 Count	971 Count
1779390624	338 Count	924 Count
1779389721	326 Count	835 Count
1779388817	310 Count	750 Count
1779387914	297 Count	726 Count
1779387011	280 Count	691 Count
1779386108	266 Count	651 Count
1779385205	250 Count	617 Count
1779384302	239 Count	566 Count
1779383398	225 Count	525 Count
1779382492	211 Count	498 Count
1779381589	194 Count	466 Count
1779380686	178 Count	421 Count
1779379783	163 Count	379 Count
1779378880	147 Count	333 Count
1779377977	128 Count	292 Count
1779377074	115 Count	267 Count
1779376171	97 Count	243 Count
1779375267	86 Count	218 Count
1779374365	65 Count	167 Count
1779373548	49 Count	140 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)