EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EA7HQG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA7HQG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1787554209	249 Count	617 Count	218 Count
1787552406	241 Count	595 Count	211 Count
1787550603	233 Count	575 Count	204 Count
1787548800	225 Count	543 Count	197 Count
1787546997	217 Count	525 Count	190 Count
1787545193	211 Count	511 Count	185 Count
1787543390	203 Count	494 Count	178 Count
1787541587	194 Count	473 Count	170 Count
1787539821	186 Count	457 Count	163 Count
1787538018	178 Count	441 Count	156 Count
1787536214	170 Count	425 Count	149 Count
1787534411	163 Count	403 Count	143 Count
1787532608	155 Count	380 Count	136 Count
1787530805	145 Count	361 Count	127 Count
1787529002	137 Count	341 Count	120 Count
1787527199	130 Count	317 Count	114 Count
1787525395	120 Count	291 Count	105 Count
1787523592	112 Count	270 Count	98 Count
1787521789	104 Count	251 Count	91 Count
1787519986	96 Count	230 Count	84 Count
1787518223	90 Count	214 Count	79 Count
1787516419	81 Count	198 Count	71 Count
1787514616	72 Count	178 Count	63 Count
1787512813	64 Count	159 Count	56 Count
1787511010	56 Count	139 Count	49 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)