EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9OE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9OE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1775484649	63 Count	739 Count	63 Count
1775482849	62 Count	724 Count	62 Count
1775481050	61 Count	717 Count	61 Count
1775479245	61 Count	717 Count	61 Count
1775477445	61 Count	717 Count	61 Count
1775475645	61 Count	717 Count	61 Count
1775473845	61 Count	709 Count	61 Count
1775472045	61 Count	701 Count	61 Count
1775470245	56 Count	688 Count	56 Count
1775468445	55 Count	684 Count	55 Count
1775466645	55 Count	684 Count	55 Count
1775464845	55 Count	684 Count	55 Count
1775463045	55 Count	684 Count	55 Count
1775461244	55 Count	682 Count	55 Count
1775459444	55 Count	682 Count	55 Count
1775457645	55 Count	682 Count	55 Count
1775455845	55 Count	682 Count	55 Count
1775454045	55 Count	682 Count	55 Count
1775452245	55 Count	682 Count	55 Count
1775450445	55 Count	682 Count	55 Count
1775448644	55 Count	682 Count	55 Count
1775446844	55 Count	682 Count	55 Count
1775445044	55 Count	682 Count	55 Count
1775443244	55 Count	682 Count	55 Count
1775441444	55 Count	682 Count	55 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)