EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR8RZE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8RZE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1775486940	176 Count	814 Count	111 Count
1775486039	174 Count	808 Count	110 Count
1775485139	172 Count	791 Count	109 Count
1775484238	170 Count	778 Count	109 Count
1775483365	166 Count	769 Count	109 Count
1775482464	163 Count	753 Count	107 Count
1775480663	161 Count	738 Count	107 Count
1775479762	152 Count	700 Count	99 Count
1775478861	150 Count	685 Count	98 Count
1775477961	149 Count	638 Count	98 Count
1775477047	148 Count	632 Count	98 Count
1775476146	142 Count	615 Count	93 Count
1775475246	139 Count	602 Count	91 Count
1775473445	137 Count	596 Count	91 Count
1775472545	127 Count	579 Count	82 Count
1775471643	124 Count	564 Count	80 Count
1775470743	123 Count	560 Count	80 Count
1775469842	120 Count	550 Count	78 Count
1775468942	113 Count	528 Count	72 Count
1775468041	111 Count	519 Count	71 Count
1775467140	109 Count	510 Count	70 Count
1775466240	106 Count	497 Count	68 Count
1775465339	103 Count	486 Count	66 Count
1775464439	100 Count	472 Count	64 Count
1775463538	98 Count	458 Count	63 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)