EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F5ZMX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZMX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1783295182	270 Count	452 Count	243 Count
1783294279	266 Count	439 Count	240 Count
1783293376	260 Count	426 Count	235 Count
1783292472	256 Count	417 Count	232 Count
1783291569	250 Count	407 Count	227 Count
1783290666	246 Count	397 Count	224 Count
1783289762	240 Count	387 Count	219 Count
1783288859	236 Count	377 Count	216 Count
1783287955	231 Count	362 Count	212 Count
1783287052	227 Count	352 Count	209 Count
1783286149	221 Count	340 Count	204 Count
1783285245	218 Count	330 Count	202 Count
1783284341	212 Count	316 Count	197 Count
1783283438	208 Count	306 Count	194 Count
1783282530	202 Count	292 Count	189 Count
1783281626	199 Count	283 Count	187 Count
1783280723	195 Count	271 Count	184 Count
1783279820	191 Count	260 Count	181 Count
1783278915	186 Count	250 Count	177 Count
1783278012	160 Count	222 Count	152 Count
1783277195	144 Count	199 Count	137 Count
1783276291	140 Count	189 Count	134 Count
1783275387	134 Count	176 Count	129 Count
1783274483	127 Count	162 Count	123 Count
1783273580	105 Count	133 Count	102 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)