EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8SOB-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8SOB-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1790096622	456 Count	655 Count	269 Count
1790095722	453 Count	653 Count	267 Count
1790094821	451 Count	651 Count	266 Count
1790093020	446 Count	648 Count	263 Count
1790092119	443 Count	646 Count	261 Count
1790091219	439 Count	642 Count	258 Count
1790090318	436 Count	602 Count	256 Count
1790089417	434 Count	561 Count	255 Count
1790088517	433 Count	526 Count	255 Count
1790087616	432 Count	486 Count	255 Count
1790086716	429 Count	445 Count	253 Count
1790085815	427 Count	408 Count	252 Count
1790084914	425 Count	365 Count	251 Count
1790084014	418 Count	354 Count	245 Count
1790083113	415 Count	350 Count	243 Count
1790082213	412 Count	348 Count	241 Count
1790081312	409 Count	345 Count	239 Count
1790080411	407 Count	344 Count	238 Count
1790078610	403 Count	340 Count	236 Count
1790077709	401 Count	339 Count	235 Count
1790076809	399 Count	338 Count	234 Count
1790075909	393 Count	332 Count	229 Count
1790075008	391 Count	330 Count	228 Count
1790072309	385 Count	326 Count	225 Count
1790071405	383 Count	324 Count	224 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)