EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9IKM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IKM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1779380462	243 Count	556 Count	184 Count
1779379562	236 Count	547 Count	178 Count
1779378661	225 Count	532 Count	168 Count
1779377760	217 Count	524 Count	161 Count
1779376860	214 Count	518 Count	159 Count
1779375959	211 Count	515 Count	157 Count
1779375058	199 Count	501 Count	146 Count
1779374158	192 Count	492 Count	140 Count
1779373257	190 Count	489 Count	139 Count
1779372356	187 Count	483 Count	137 Count
1779371456	180 Count	475 Count	131 Count
1779370555	176 Count	464 Count	128 Count
1779369654	173 Count	454 Count	126 Count
1779368754	160 Count	436 Count	114 Count
1779367853	155 Count	411 Count	110 Count
1779366952	142 Count	369 Count	98 Count
1779366052	138 Count	353 Count	95 Count
1779365166	136 Count	346 Count	94 Count
1779364265	134 Count	337 Count	93 Count
1779363364	132 Count	326 Count	92 Count
1779362464	129 Count	314 Count	90 Count
1779361563	125 Count	303 Count	87 Count
1779360662	122 Count	291 Count	85 Count
1779359762	119 Count	281 Count	83 Count
1779358861	116 Count	260 Count	81 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)