EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

M0MXL Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M0MXL. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1775476688	883 Count	1000 Count	767 Count
1775474884	876 Count	992 Count	761 Count
1775473127	869 Count	983 Count	755 Count
1775471323	862 Count	960 Count	749 Count
1775469519	854 Count	952 Count	742 Count
1775467715	847 Count	944 Count	736 Count
1775465911	839 Count	935 Count	729 Count
1775464107	832 Count	927 Count	723 Count
1775462303	825 Count	919 Count	717 Count
1775460499	817 Count	910 Count	710 Count
1775458695	810 Count	902 Count	704 Count
1775456891	802 Count	893 Count	697 Count
1775455087	795 Count	885 Count	691 Count
1775453283	787 Count	876 Count	684 Count
1775451528	781 Count	869 Count	679 Count
1775447920	766 Count	853 Count	666 Count
1775446116	757 Count	843 Count	658 Count
1775444312	751 Count	836 Count	653 Count
1775442508	743 Count	827 Count	646 Count
1775440704	738 Count	821 Count	642 Count
1775438900	729 Count	811 Count	634 Count
1775437096	723 Count	804 Count	629 Count
1775435293	715 Count	795 Count	622 Count
1775433489	708 Count	787 Count	616 Count
1775431685	701 Count	779 Count	610 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)