EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6TPX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6TPX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1775485900	10 Count	192 Count
1775484097	9 Count	174 Count
1775482294	8 Count	155 Count
1775480491	7 Count	137 Count
1775478687	6 Count	119 Count
1775476884	5 Count	105 Count
1775475081	4 Count	86 Count
1775473278	3 Count	70 Count
1775471475	2 Count	59 Count
1775469709	1 Count	38 Count
1775467905	0 Count	21 Count
1775466102	66 Count	1011 Count
1775464299	65 Count	983 Count
1775462496	64 Count	963 Count
1775460693	63 Count	944 Count
1775458890	62 Count	927 Count
1775457087	61 Count	906 Count
1775455284	60 Count	891 Count
1775453481	59 Count	877 Count
1775451677	58 Count	862 Count
1775449874	57 Count	845 Count
1775448108	56 Count	823 Count
1775446305	55 Count	799 Count
1775444502	54 Count	778 Count
1775442698	53 Count	762 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)