EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F5ZZW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZZW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1783304838	155 Count	522 Count	82 Count
1783304231	153 Count	517 Count	81 Count
1783303019	150 Count	513 Count	80 Count
1783302413	148 Count	510 Count	79 Count
1783301807	146 Count	506 Count	78 Count
1783301200	144 Count	502 Count	77 Count
1783300594	142 Count	499 Count	76 Count
1783299988	140 Count	497 Count	75 Count
1783299382	138 Count	494 Count	74 Count
1783298776	136 Count	490 Count	73 Count
1783298169	134 Count	486 Count	72 Count
1783297563	132 Count	482 Count	71 Count
1783297177	130 Count	478 Count	70 Count
1783296571	128 Count	473 Count	69 Count
1783295964	126 Count	469 Count	68 Count
1783295358	124 Count	465 Count	67 Count
1783294752	122 Count	462 Count	66 Count
1783294146	120 Count	457 Count	65 Count
1783293540	118 Count	453 Count	64 Count
1783292933	116 Count	449 Count	63 Count
1783292327	114 Count	445 Count	62 Count
1783291721	112 Count	441 Count	61 Count
1783291115	110 Count	437 Count	60 Count
1783290509	108 Count	432 Count	59 Count
1783289902	106 Count	428 Count	58 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)