EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

YC2SNK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YC2SNK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1787547786	22 Count	342 Count
1787545982	21 Count	323 Count
1787544178	20 Count	306 Count
1787542374	19 Count	290 Count
1787540570	18 Count	269 Count
1787538766	17 Count	243 Count
1787536962	16 Count	216 Count
1787535158	15 Count	180 Count
1787533354	14 Count	159 Count
1787532655	13 Count	159 Count
1787531696	12 Count	158 Count
1787530795	11 Count	158 Count
1787529652	10 Count	158 Count
1787528449	9 Count	158 Count
1787507075	8 Count	158 Count
1787502625	7 Count	158 Count
1787500821	6 Count	138 Count
1787499017	5 Count	120 Count
1787497213	4 Count	100 Count
1787495410	3 Count	82 Count
1787493606	2 Count	60 Count
1787491798	1 Count	36 Count
1787489994	0 Count	18 Count
1787488231	56 Count	1007 Count
1787486427	55 Count	988 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)