EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PD-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PD-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1775486573	124 Count	1040 Count	94 Count
1775485672	118 Count	997 Count	89 Count
1775484771	115 Count	960 Count	87 Count
1775483871	111 Count	916 Count	84 Count
1775482970	107 Count	882 Count	81 Count
1775482068	101 Count	839 Count	76 Count
1775481168	97 Count	805 Count	73 Count
1775480267	91 Count	761 Count	68 Count
1775479366	88 Count	729 Count	66 Count
1775478466	84 Count	690 Count	63 Count
1775477565	81 Count	660 Count	61 Count
1775476664	76 Count	622 Count	57 Count
1775475763	72 Count	589 Count	54 Count
1775474863	67 Count	552 Count	50 Count
1775473962	63 Count	523 Count	47 Count
1775473061	58 Count	482 Count	43 Count
1775472161	53 Count	454 Count	39 Count
1775471260	48 Count	419 Count	35 Count
1775470359	43 Count	382 Count	31 Count
1775469459	37 Count	342 Count	26 Count
1775468558	32 Count	306 Count	22 Count
1775467674	24 Count	257 Count	19 Count
1775466773	20 Count	222 Count	16 Count
1775465873	15 Count	174 Count	12 Count
1775464972	11 Count	140 Count	9 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)