EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2INO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2INO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1787543953	36 Count	422 Count	12 Count
1787542152	33 Count	376 Count	11 Count
1787540352	30 Count	341 Count	10 Count
1787538551	27 Count	310 Count	9 Count
1787536750	24 Count	271 Count	8 Count
1787534949	21 Count	238 Count	7 Count
1787533149	18 Count	195 Count	6 Count
1787531348	14 Count	156 Count	4 Count
1787529547	11 Count	116 Count	3 Count
1787527746	8 Count	81 Count	2 Count
1787524153	77 Count	1039 Count	26 Count
1787522352	74 Count	993 Count	25 Count
1787520551	71 Count	957 Count	24 Count
1787518750	68 Count	921 Count	23 Count
1787516950	64 Count	883 Count	21 Count
1787515149	61 Count	846 Count	20 Count
1787513348	58 Count	811 Count	19 Count
1787511548	55 Count	767 Count	18 Count
1787509747	52 Count	731 Count	17 Count
1787507946	49 Count	697 Count	16 Count
1787506146	46 Count	656 Count	15 Count
1787502552	36 Count	558 Count	12 Count
1787500751	33 Count	498 Count	11 Count
1787498950	30 Count	453 Count	10 Count
1787497149	27 Count	410 Count	9 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)