EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F6DAY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6DAY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791449369	980 Count	789 Count	652 Count
1791448405	976 Count	785 Count	649 Count
1791447442	974 Count	783 Count	648 Count
1791446477	971 Count	780 Count	646 Count
1791445513	968 Count	777 Count	644 Count
1791444549	965 Count	774 Count	642 Count
1791443585	961 Count	771 Count	639 Count
1791442621	959 Count	770 Count	638 Count
1791441657	955 Count	767 Count	635 Count
1791440693	952 Count	765 Count	633 Count
1791439729	948 Count	761 Count	630 Count
1791438765	946 Count	760 Count	629 Count
1791438374	944 Count	759 Count	628 Count
1791437410	940 Count	756 Count	625 Count
1791436446	937 Count	754 Count	623 Count
1791435482	934 Count	752 Count	621 Count
1791434518	931 Count	750 Count	619 Count
1791433553	928 Count	748 Count	617 Count
1791432590	926 Count	747 Count	616 Count
1791431625	924 Count	746 Count	615 Count
1791430661	922 Count	745 Count	614 Count
1791429697	917 Count	741 Count	610 Count
1791428733	915 Count	740 Count	609 Count
1791427769	912 Count	738 Count	607 Count
1791426805	908 Count	734 Count	604 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)