EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

HB9EZW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HB9EZW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1771571419	233 Count	523 Count	81 Count
1771570516	232 Count	521 Count	81 Count
1771569613	230 Count	519 Count	80 Count
1771568710	229 Count	516 Count	80 Count
1771567807	228 Count	514 Count	80 Count
1771566903	226 Count	512 Count	79 Count
1771566001	225 Count	511 Count	79 Count
1771565097	224 Count	510 Count	79 Count
1771564194	223 Count	508 Count	79 Count
1771563291	222 Count	507 Count	79 Count
1771562388	221 Count	505 Count	79 Count
1771561485	220 Count	503 Count	79 Count
1771560582	218 Count	500 Count	78 Count
1771559679	217 Count	498 Count	78 Count
1771558776	216 Count	495 Count	78 Count
1771557873	215 Count	493 Count	78 Count
1771556969	214 Count	491 Count	78 Count
1771556066	212 Count	489 Count	77 Count
1771555163	211 Count	486 Count	77 Count
1771554260	210 Count	484 Count	77 Count
1771553357	208 Count	481 Count	76 Count
1771552454	206 Count	478 Count	75 Count
1771551624	204 Count	476 Count	74 Count
1771550721	203 Count	474 Count	74 Count
1771549818	202 Count	472 Count	74 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)