EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8PB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8PB-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1779398895	206 Count	350 Count	123 Count
1779397994	203 Count	345 Count	121 Count
1779397093	200 Count	340 Count	119 Count
1779396192	197 Count	335 Count	117 Count
1779395292	195 Count	331 Count	116 Count
1779394391	192 Count	326 Count	114 Count
1779393490	189 Count	321 Count	112 Count
1779392589	187 Count	318 Count	111 Count
1779391689	185 Count	315 Count	110 Count
1779390788	182 Count	310 Count	108 Count
1779389887	179 Count	305 Count	106 Count
1779388986	177 Count	302 Count	105 Count
1779388086	175 Count	299 Count	104 Count
1779387185	173 Count	295 Count	103 Count
1779386284	171 Count	291 Count	102 Count
1779385383	168 Count	286 Count	100 Count
1779384483	165 Count	281 Count	98 Count
1779383582	163 Count	277 Count	97 Count
1779382681	161 Count	273 Count	96 Count
1779381781	158 Count	268 Count	94 Count
1779380880	156 Count	264 Count	93 Count
1779379979	153 Count	259 Count	91 Count
1779379078	151 Count	255 Count	90 Count
1779378178	148 Count	251 Count	88 Count
1779377277	146 Count	247 Count	87 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)