EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

PA1MT-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA1MT-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1787563092	449 Count	999 Count
1787561289	448 Count	996 Count
1787559523	443 Count	993 Count
1787557720	442 Count	990 Count
1787555916	441 Count	987 Count
1787554113	440 Count	984 Count
1787552309	439 Count	981 Count
1787550506	438 Count	978 Count
1787548703	437 Count	975 Count
1787546899	436 Count	972 Count
1787545096	435 Count	969 Count
1787543293	434 Count	966 Count
1787541489	433 Count	963 Count
1787539686	432 Count	960 Count
1787537920	427 Count	957 Count
1787536117	426 Count	954 Count
1787534314	425 Count	951 Count
1787532510	424 Count	948 Count
1787530707	423 Count	945 Count
1787528904	422 Count	942 Count
1787527100	421 Count	939 Count
1787525297	420 Count	936 Count
1787523493	419 Count	933 Count
1787521690	418 Count	930 Count
1787519887	417 Count	927 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)