EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3PSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3PSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1783289115	68 Count	376 Count	54 Count
1783287314	61 Count	339 Count	48 Count
1783285522	50 Count	297 Count	42 Count
1783283721	44 Count	269 Count	37 Count
1783281920	35 Count	232 Count	29 Count
1783280119	29 Count	198 Count	24 Count
1783278319	25 Count	178 Count	21 Count
1783276518	18 Count	142 Count	15 Count
1783274717	14 Count	106 Count	12 Count
1783272916	10 Count	75 Count	9 Count
1783271115	6 Count	46 Count	6 Count
1783269314	139 Count	1028 Count	112 Count
1783267514	134 Count	988 Count	108 Count
1783265713	128 Count	949 Count	103 Count
1783263921	118 Count	921 Count	98 Count
1783262120	114 Count	900 Count	95 Count
1783260319	109 Count	877 Count	91 Count
1783258518	104 Count	834 Count	87 Count
1783256717	99 Count	802 Count	83 Count
1783254917	95 Count	769 Count	80 Count
1783253116	89 Count	740 Count	75 Count
1783251315	85 Count	724 Count	72 Count
1783249514	78 Count	691 Count	66 Count
1783247713	73 Count	665 Count	62 Count
1783245913	67 Count	636 Count	57 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)