EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ3NVZ-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3NVZ-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791446097	187 Count	863 Count	77 Count
1791444295	184 Count	822 Count	75 Count
1791442494	175 Count	765 Count	72 Count
1791440692	166 Count	688 Count	69 Count
1791438891	147 Count	615 Count	65 Count
1791437090	136 Count	529 Count	63 Count
1791435289	132 Count	447 Count	60 Count
1791433487	116 Count	383 Count	57 Count
1791431685	112 Count	368 Count	54 Count
1791429884	109 Count	361 Count	52 Count
1791428083	104 Count	349 Count	49 Count
1791426282	101 Count	340 Count	47 Count
1791424481	96 Count	333 Count	43 Count
1791422679	93 Count	324 Count	41 Count
1791420878	89 Count	315 Count	38 Count
1791419106	86 Count	305 Count	36 Count
1791417305	82 Count	295 Count	33 Count
1791415504	79 Count	283 Count	31 Count
1791413703	75 Count	272 Count	28 Count
1791411901	72 Count	260 Count	26 Count
1791410100	68 Count	248 Count	23 Count
1791408299	65 Count	240 Count	21 Count
1791406498	61 Count	228 Count	18 Count
1791404697	58 Count	200 Count	16 Count
1791402895	49 Count	163 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)