EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SM0PQB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SM0PQB-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1771567998	12 Count	109 Count
1771566195	11 Count	98 Count
1771564392	10 Count	84 Count
1771562589	9 Count	74 Count
1771560820	4 Count	62 Count
1771559017	3 Count	50 Count
1771557214	2 Count	37 Count
1771555410	1 Count	25 Count
1771553607	0 Count	11 Count
1771551804	115 Count	1002 Count
1771550001	114 Count	989 Count
1771548198	113 Count	978 Count
1771546395	112 Count	963 Count
1771542789	110 Count	938 Count
1771540986	109 Count	928 Count
1771539217	104 Count	915 Count
1771537414	103 Count	903 Count
1771535611	102 Count	894 Count
1771533808	101 Count	882 Count
1771532005	100 Count	868 Count
1771530202	99 Count	857 Count
1771528399	98 Count	843 Count
1771526596	97 Count	833 Count
1771524792	96 Count	819 Count
1771522989	95 Count	809 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)