EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SM0PQB-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SM0PQB-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1779468130	99 Count	794 Count
1779464558	93 Count	773 Count
1779462755	92 Count	761 Count
1779459149	90 Count	738 Count
1779457345	89 Count	727 Count
1779455543	88 Count	716 Count
1779453739	87 Count	704 Count
1779451936	86 Count	693 Count
1779450133	85 Count	681 Count
1779448330	84 Count	671 Count
1779446527	83 Count	658 Count
1779444724	82 Count	647 Count
1779442955	77 Count	637 Count
1779441152	76 Count	625 Count
1779439349	75 Count	613 Count
1779433939	72 Count	580 Count
1779432136	71 Count	568 Count
1779430333	70 Count	557 Count
1779428530	69 Count	545 Count
1779426727	68 Count	535 Count
1779424924	67 Count	522 Count
1779423121	66 Count	511 Count
1779421353	61 Count	501 Count
1779419549	60 Count	489 Count
1779417746	59 Count	477 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)