EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F4GMT-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GMT-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1791454096	160 Count	336 Count
1791453213	155 Count	333 Count
1791452312	154 Count	331 Count
1791451411	153 Count	328 Count
1791450511	152 Count	326 Count
1791449610	151 Count	323 Count
1791448709	150 Count	321 Count
1791447808	149 Count	318 Count
1791446908	148 Count	316 Count
1791446006	147 Count	313 Count
1791445105	146 Count	311 Count
1791444204	145 Count	308 Count
1791443303	144 Count	306 Count
1791442403	143 Count	303 Count
1791441502	142 Count	301 Count
1791440601	141 Count	298 Count
1791439700	140 Count	296 Count
1791438800	139 Count	293 Count
1791437899	138 Count	291 Count
1791436998	137 Count	288 Count
1791436098	136 Count	286 Count
1791435197	135 Count	283 Count
1791434296	134 Count	281 Count
1791433395	133 Count	278 Count
1791432494	132 Count	276 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)