EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

LB3AG-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LB3AG-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787549052	199 Count	437 Count	127 Count
1787548449	195 Count	428 Count	124 Count
1787547846	192 Count	420 Count	122 Count
1787547243	190 Count	416 Count	121 Count
1787546640	186 Count	409 Count	118 Count
1787546037	184 Count	400 Count	117 Count
1787545434	182 Count	395 Count	116 Count
1787544830	179 Count	385 Count	114 Count
1787544227	176 Count	379 Count	112 Count
1787543624	174 Count	373 Count	111 Count
1787543021	171 Count	365 Count	109 Count
1787542418	169 Count	358 Count	108 Count
1787541815	167 Count	352 Count	107 Count
1787541212	164 Count	343 Count	105 Count
1787540609	162 Count	336 Count	104 Count
1787540006	160 Count	329 Count	103 Count
1787539403	157 Count	324 Count	101 Count
1787538800	154 Count	317 Count	99 Count
1787538197	152 Count	313 Count	98 Count
1787537594	149 Count	306 Count	96 Count
1787537101	147 Count	303 Count	95 Count
1787536498	145 Count	299 Count	94 Count
1787535895	142 Count	292 Count	92 Count
1787535292	138 Count	282 Count	89 Count
1787534688	136 Count	277 Count	88 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)