EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

HB9IMG Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HB9IMG. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1771569387	303 Count	910 Count
1771567584	302 Count	905 Count
1771565780	301 Count	899 Count
1771563977	300 Count	898 Count
1771562174	299 Count	897 Count
1771560371	298 Count	895 Count
1771558568	297 Count	890 Count
1771556764	296 Count	887 Count
1771553194	290 Count	877 Count
1771551391	289 Count	870 Count
1771549587	288 Count	865 Count
1771547784	287 Count	859 Count
1771545981	286 Count	856 Count
1771544178	285 Count	851 Count
1771542375	284 Count	847 Count
1771540571	283 Count	840 Count
1771538768	282 Count	834 Count
1771536965	281 Count	828 Count
1771535162	280 Count	825 Count
1771531591	274 Count	812 Count
1771529788	273 Count	805 Count
1771527985	272 Count	799 Count
1771526181	271 Count	792 Count
1771524378	270 Count	788 Count
1771522575	269 Count	782 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)