EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2AJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2AJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791446511	169 Count	232 Count	157 Count
1791445610	163 Count	222 Count	152 Count
1791444709	159 Count	215 Count	149 Count
1791443808	153 Count	206 Count	144 Count
1791442908	146 Count	195 Count	138 Count
1791442007	134 Count	179 Count	127 Count
1791441106	112 Count	153 Count	106 Count
1791440205	93 Count	128 Count	88 Count
1791439305	83 Count	112 Count	79 Count
1791438404	67 Count	90 Count	64 Count
1791437503	44 Count	64 Count	42 Count
1791436602	34 Count	49 Count	33 Count
1791435702	23 Count	31 Count	23 Count
1791434801	647 Count	1012 Count	583 Count
1791433900	627 Count	985 Count	564 Count
1791432999	619 Count	965 Count	557 Count
1791432098	604 Count	937 Count	543 Count
1791431198	595 Count	916 Count	535 Count
1791430317	587 Count	901 Count	528 Count
1791429416	579 Count	881 Count	521 Count
1791428515	569 Count	865 Count	512 Count
1791427614	560 Count	845 Count	504 Count
1791426713	549 Count	826 Count	494 Count
1791425813	539 Count	804 Count	485 Count
1791424912	528 Count	785 Count	475 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)