EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

CR7BQX-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CR7BQX-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1771569648	0 Count	8 Count
1771567846	167 Count	1006 Count
1771566045	166 Count	998 Count
1771564244	165 Count	991 Count
1771562442	164 Count	983 Count
1771560661	163 Count	979 Count
1771558859	162 Count	973 Count
1771557058	161 Count	967 Count
1771555256	160 Count	959 Count
1771553455	159 Count	944 Count
1771551654	158 Count	938 Count
1771549852	157 Count	932 Count
1771548051	156 Count	926 Count
1771546249	155 Count	919 Count
1771544448	154 Count	913 Count
1771542646	153 Count	905 Count
1771540845	152 Count	900 Count
1771539058	151 Count	896 Count
1771537256	150 Count	890 Count
1771535455	149 Count	884 Count
1771533653	148 Count	876 Count
1771531852	147 Count	860 Count
1771530051	146 Count	853 Count
1771528249	145 Count	846 Count
1771526448	144 Count	839 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)