EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F4GCF-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GCF-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1785080008	629 Count	325 Count
1785079408	594 Count	307 Count
1785078807	564 Count	291 Count
1785078207	546 Count	280 Count
1785077607	517 Count	268 Count
1785077007	481 Count	250 Count
1785076407	441 Count	230 Count
1785075807	410 Count	210 Count
1785075207	378 Count	193 Count
1785074607	351 Count	175 Count
1785074007	329 Count	164 Count
1785073407	313 Count	152 Count
1785072807	302 Count	147 Count
1785072206	288 Count	140 Count
1785071606	271 Count	134 Count
1785071006	257 Count	127 Count
1785070406	240 Count	119 Count
1785069806	215 Count	111 Count
1785069206	202 Count	104 Count
1785068606	184 Count	96 Count
1785068006	174 Count	89 Count
1785067406	163 Count	83 Count
1785066805	148 Count	74 Count
1785066205	134 Count	65 Count
1785065605	115 Count	58 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)